Selection Wheel And Switch Settings - Adjustment - Indicators; Description; Setting According To The Batteries Type - Cristec CPS3 12V/80A Manuel D'utilisation

3.3. SELECTION WHEEL AND SWITCH SETTINGS – ADJUSTMENT - INDICATORS

3.3.1. Description

The CPS3 chargers are equipped with a selection wheel (RC1) allowing to set up the charger
according the battery type and the application.
Setting thanks to a small flat head screw driver (width 2,5mm) and turn in clockwise direction.
The CPS3 chargers are equipped with a Boost function for a faster charge of the batteries. This
function is controlled by a timeout (see table here after) and is automatically inhibited when the
battery is fully charged : stoppage of the boost for I batteries < 15% of I rated charger.
The Boost function can also be disabled by means of a switch (SW1).
Setting by selecting the switch

3.3.2. Setting according to the batteries type

(*) Voltage on BAT 1 / BAT 2 with 10% of the rated current and a tolerance of +/- 1%.
The voltage on +BATD is lower than 0,2V (approx.) at 10% of the charger rated current and 0,4V (approx.) at
100% of the charger rated current.
The voltage on +SP is higher than 0,3V (approx.) at 10% of the charger rated current and 0,4V (approx.) at 100%
of the charger rated current.
CPS3-3M-DED
22
www.busse-yachtshop.de | info@busse-yachtshop.de