Changing Vacuum Level; Placing Out Of Operation After Use - Medela Clario Toni Mode D'emploi

WARNINGS
For use only by medically trained persons who have been adequately trained in suction
procedures and in the use of aspirators� Wear gloves for all operations�
7.4
Changing vacuum
level
7.5
Placing out of
operation after use
18 |
Operating instructions
1�
1�
2� If the pump is connected
to a fixed mains socket:
or
If the pump is connected
to a 12 VDC power source:
3� Clean and desinfect the Clario Toni� See chapter 16�
1�1 Set vacuum regulator to
the necessary position�
1�1 Press the On / off button to
switch off the pump�
Disconnect the mains plug
from the fixed mains socket�
Disconnect the 12 VDC
plug from the 12 VDC
power source�