Changing Flow Rate; Changing Vacuum Level; Placing Out Of Operation After Use - Medela Dominant Flex Mode D'emploi

CAUTIONS
When the Dominant Flex is used for wound drainage, the negative pressure should be set
according to instruction of the specialist and not cause any wound damage�
7.3

Changing flow rate

7.4
Changing vacuum
level
7.5
Placing out of
operation after use
1�
or
or
2�
1�
2�
3� Clean and disinfect the Dominant Flex� See chapter 14�
1�1 Change flow rate accord-
ing to operator preference�
After switching on the
pump (with either the foot
switch or the button on
the pump), it will start
running in the 50l/min�
mode�
1�2 Touch to change to:
60 l/min: turbo mode
50 l/min: nominal mode
40 l/min: whisper mode
2�1 Clamp patient tubing
2�2 Turn vacuum regulator to
select the correct vacuum
according to the particular
application�
2�3 Check vacuum gauge for
setting�
1�1 Touch on/off button to
switch off the Dominant
Flex�
2�1 Disconnect the mains
plug from the fixed mains
socket�
Operating instructions
| 19