Dmx-Controlled Operation; Addressing; Dmx-Protocol - Futurelight CY-260 Mode D'emploi

Disconnect the CY-260 from the controller and select "Master Mode: Sound-control".
If you have connected a footswitch to the Blackout-socket, you can lock the light output (Blackout-mode) and
turn it on again.
Master/Slave-operation
Connect the master and slave-devices and adjust the settings as desribed above.
Please note: If you wish to change from one operating mode into another, you have to unplug the projector
from the mains and plug it again.

DMX-controlled operation

You can control the projectors individually via your DMX-controller. Every DMX-channel has a different
occupation with different features. In order to call up the different features, you first have to open the shutter
(control channel 6, DMX-value 132-139 or 250-255) or set the dimmer to the desired intensity (control
channel 6, DMX-value 6-128).

Addressing

The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the CY-260 will respond to the controller.
If you set, for example, the address to channel 7, the CY-260 will use the channel 7 to 12 for control.
Please, be sure that you don't have any overlapping channels in order to control each CY-260 correctly and
independently from any other fixture on the DMX data link.
If two, three or more CY-260 are addressed similarly, they will work similarly.
For address setting, press the Mode-button until the display shows "d" and set the desired address via the
Up/Down-buttons.
Controlling:
After having addressed all CY-260, you may now start operating these via your lighting controller.
Note:
After switching on, the CY-260 will automatically detect whether DMX 512 data is received or not. If the data
is received, the control LED flashes. If there is no data received at the DMX-input, the control LED lights up
permanently.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the CY-260.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
Note:
It's necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order to
ensure proper transmission on the DMX data link.

DMX-protocol

Control-channel 1 - Mirrored cylinder movement
Push slider up in order to move the mirrored cylinder.
Gradual mirrored cylinder adjustment from one end of the slider to the other (0-255, 128-center).
The mirrored cylinder can be stopped at any position you wish.
Decimal Hexad. Percentage S/F Feature
0 255 00 FF 0% 100% S Gradual adjustment of the mirrored cylinder position from left to right
28/59 51837531_V_1_0.DOC