Connection With The Mains; Operation; Stand Alone Operation; Master/Slave-Operation - Futurelight DJ-SCAN 600 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Building a serial DMX-chain:
Connect the DMX-output of the first fixture in the DMX-chain with the DMX-input of the next fixture. Always
connect one output with the input of the next fixture until all fixtures are connected.
Caution: At the last fixture, the DMX-cable has to be terminated with a terminator. Solder a 120
between Signal (–) and Signal (+) into a 3-pin XLR-plug and plug it in the DMX-output of the last fixture.

Connection with the mains

Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection-cables is as follows:
Cable
Pin
Brown
Live
Blue
Neutral
Yellow/Green
Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.

OPERATION

After you connected the effect to the mains, the DJ-SCAN 600 starts running. During the Reset, the motors
are trimmed and the device is ready for use afterwards.

Stand Alone operation

In the Stand Alone mode, the DJ-SCAN 600 can be used without controller. You can do without a controller
as the DJ-SCAN 600 features a built-in microphone, which provides automatic sound control.
Disconnect the DJ-SCAN 600 from the controller and select the desired "Master Mode".
If you have connected a footswitch to the Blackout-socket, you can lock the light output (Blackout-mode) and
turn it on again.

Master/Slave-operation

Connect the master and slave-devices and adjust the settings as desribed above.

DMX-controlled operation

You can control the projectors individually via your DMX-controller. Every DMX-channel has a different
occupation with different features. In order to call up the different features, you first have to open the light
output (control channel 6, DMX-value 250-255).
International
L
N
28/60
resistor
51839285_V_1_1.DOC

Publicité

Table des Matières
loading

Table des Matières