Addressing; Dmx-Controlled Operation; Dmx-Protocol - Futurelight EVO-WATER Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

If you are using controllers with this occupation, you can connect the DMX-output of the controller directly
with the DMX-input of the first fixture in the DMX-chain. If you wish to connect DMX-controllers with other
XLR-outputs, you need to use adapter-cables.
Building a serial DMX-chain:
Connect the DMX-output of the first fixture in the DMX-chain with the DMX-input of the next fixture. Always
connect one output with the input of the next fixture until all fixtures are connected.
Caution: At the last fixture, the DMX-cable has to be terminated with a terminator. Solder a 120
between Signal (–) and Signal (+) into a 3-pin XLR-plug and plug it in the DMX-output of the last fixture.

Addressing

Each projector occupies 7 channels. To ensure that the control signals are properly directed to each
projector, the projector requires adressing. This is to be done for every single projector by changing the DIP
switches as set out in this table.
The starting address is defined as the first channel from which the EVO-Water will respond to the controller.
Please make sure that you don't have any overlapping channels in order to control each EVO-Water
correctly and independently from any other fixture on the DMX data link. If two, three or more EVO-Water are
addressed similarly, they will work similarly.
Occupation of the DIP-switches:
Setting the DMX-
DIP-switch no.
starting address:
Projector number
DMX-starting
& channels
address
Device 1 - channels 1-7
Device 2 - channels 8-14
Device 3 - channels 15-21
Device 4 - channels 22-28
Device 5 - channels 29-35

DMX-controlled operation

You can control the projectors individually via your DMX-controller. Every DMX-channel has a different
occupation with different features.

DMX-protocol

Control channel 1 – Effect-wheel 1
Decimal Hexad. Percentage S/F
0
0 0000
0%0%
1 127 017F
0%50%
128 128 8080
50%50%
129 255 81FF
51%100%
1
2
3
4
1
2
4
8
On
Off
Off
On
Off
On
Off
On
Off
On
Off
S No rotation
F Forwards rotation with decreasing speed
S No rotation
F Backwards rotation with increasing speed
5
6
7
8
9
16
32
64 128 256
Feature
29/61
resistor
51837590_V_1_0.DOC

Publicité

Table des Matières
loading

Table des Matières