Operation; Stand Alone Operation; Dmx-Controlled Operation; Addressing - Futurelight DJ-SCAN 210 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

OPERATION

After you connected the effect to the mains, the DJ-SCAN 210 starts running. During the Reset, the motors
are trimmed and the device is ready for use afterwards.
Turn the objective-lens for adjusting the focus in order to obtain a sharp projection.

Stand Alone operation

In the Stand Alone mode, the DJ-SCAN 210 can be used without controller. You can do without a controller
as the DJ-SCAN 210features a built-in microphone, which provides automatic sound control.
Disconnect the DJ-SCAN 210 from the controller and select "Master Mode: Sound-control".
If you have connected a footswitch to the Blackout-socket, you can lock the light output (Blackout-mode) and
turn it on again.
Master/Slave-operation
Connect the master and slave-devices and adjust the settings as desribed above.
Please note: If you wish to change from one operating mode into another, you have to unplug the projector
from the mains and plug it again.

DMX-controlled operation

You can control the projectors individually via your DMX-controller. Every DMX-channel has a different
occupation with different features. In order to call up the different features, you first have to open the light
output (control channel 4, DMX-value 251-255).

Addressing

The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the DJ-SCAN 210 will respond to the controller.
Please, be sure that you don't have any overlapping channels in order to control each DJ-SCAN 210
correctly and independently from any other fixture on the DMX data link.
If two, three or more DJ-SCAN 210 are addressed similarly, they will work similarly.
For address setting, press the Mode-button until the display shows "d" and set the desired address via the
Up/Down-buttons.
Controlling:
After having addressed all DJ-SCAN 210, you may now start operating these via your lighting controller.
Note:
After switching on, the DJ-SCAN 210 will automatically detect whether DMX 512 data is received or not. If
the data is received, the control LED flashes. If there is no data received at the DMX-input, the control LED
lights up permanently.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the DJ-SCAN
210.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
Note:
It's necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order to
ensure proper transmission on the DMX data link.
29/60
51839230_V_1_1.DOC

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Dmx-scanner

Table des Matières