After-Season Maintenance, Machine Storage; Machine Disposal - AGS Seko FRONTJET AP 105 Mode D'emploi

9.

AFTER-SEASON MAINTENANCE, MACHINE STORAGE

After the end of the season, or if the machine is not used for more than 30 days, it is advisable to prepare it immediately for the
storage.
If the fuel stays in the tank without a motion for more than 30 days, sticky sediment may come into being. This can have an
adverse effect upon the carburettor and be a cause of the wrong funcion of the engine. That is the reason for emptying the tank.
Never store the mowing machine with the full tank inside the buildings or in badly ventilated
spaces where there are fuel vapours, naked fl ame, sparking or ignition fl ames, furnace, central heating, dry rags, etc.
Handle the fuels and lubricants carefully as they are highly combustible, and a careless handling may cause serious
Carry out the emptying of the tank only into the approved vessel outdoor without naked fl ame.
Recommended procedure of preparations for the mowing machine storage:
• Clean the whole machine thoroughly.
• Replace the faulty or worn out parts and tighten all loosened screws and nuts.
• Prepare the engine for the storage according to the engine operating and maintenance instructions.
• Lubricate all lubricating points according to the lubricating plan (see the chapter 7.13).
• Slacken the V-belt of the mowing mechanism drive (see the chapter 7.9.1)
• Take out the accumulator, clean it, refi ll it with distilled water up to the lower parts of fi lling holes rings and charge it
fully. Uncharged accumulator may freeze and burst. Store the accumulator, if need be, in a cold and dry place. Charge the
accumulator every 30 days and check its voltage regularly.
• Store the mowing machine covered in a clean and dry place.
The best way how to ensure the maximum serviceability of the mowing machine for the next season is an annual check and
adjustment by the authorized service.

10. MACHINE DISPOSAL

The mowing machine user is obliged to dispose the machine after the end of its service life. This may be done in two ways:
a) To hand the machine over to a fi rm which is engaged in this activity (scrap yard, car cemetery, etc.) You will receive the due
document of handing the machine over to the disposal.
b) To dispose the machine by Yourself. In this case we recommend to proceed in the following way:
• Carry out the disposal with utilization of the secondary raw materials in accordance with the applicable enactment on waste
materials.
• Dismantle the machine completely.
• Clean the parts which can be still utilized, conserve and store them for further use.
• Separate the other parts to the parts ecologically unharmful and to the parts endangering the environment, e.g. the rubber
parts (sealing rings), residues of lubricants in bearings or gearings. Ecollogically harmful components have to be treated
in accordance with the applicable enactment on waste materials valid in the country of the machine user, e.g. in the Czech
republic it is the Law on waste materials no.185/2001 Sb.
• Separate the disposed material according to the Waste catalogue in compliance with the applicable regulation. Ecollogically
unharmful parts may be treated as the scrap.
WARNING !!!
burns to You or damage to the property.
43