Machine Unpacking; Check Aft Er Unpacking; Dispose Of Package; Preparation For Putting Into Operation - AGS Seko FRONTJET AP 105 Mode D'emploi

4 .

MACHINE UNPACKING

The self-propelled mowing machine is delivered in crates reinforced with cratewood. Some machine groups have been dismantled
in the manufacturing plant due to the transport reasons. They will be reassembled before the machine putting into operation. The
machine unpacking and preparation for the operation is carried out by the vendor within the framework of preselling service.
4.1 CHECKING AFTER UNPACKING
After removing the wrapping take down carefully the machine from the pallet - use the ramps otherwise there is a risk of the machine
damage. Check if the machine was not damaged during the transport. Unpack also all dismantled groups and check them.
In the basic packing are delivered:
• mowing machine
• steering wheel
• seat
• documentation (packing list, mowing machine operator's manual, engine operating instructions, accumulator operating
instructions, Service book)

4.1.1 DISPOSE OF PACKAGE

After the machine unpacking it is necessary to dispose of the wrapping. When disposing, observe the appurtenant law. Separate
the packing material according to the appropriate packaging catalogue. This procedure can be entrusted to a specialized fi rm.
4.2

PREPARATION FOR PUTTING INTO OPERATION

With respect to the technical character of this work, the mowing machine preparation into operation is carried out by Your vendor
(in accordance with the instructions of the machine manufacturer).

4.2.1 ASSEMBLY OF STEERING WHEEL

Place the machine on an even surface and align the front wheels into straight
direction. Mount the steering wheel and lock it in the corresponding hole of the
chosen position of height by the pin supplied.

4.2.2 ASSEMBLY OF SEAT

Remove the seat wrapping cover. Put the seat on its place in the machine and fasten it by
means of screws being preassembled in the seat.
4.2.3

SEAT POSITION ADJUSTMENT

Adjust the position of the seat in the following way:
Loosen the screws with plastic roses. Shift the seat forward or backward to the desired
position. Retighten the screws with plastic roses.

4.2.4 CONNECTION OF ACCUMULATOR

When putting the accumulator into operation, proceed according to the instructions
stated in the Accumulator operating instructions. The accumulator is placed under the
engine bonnet on the right-hand side of the seat.
Loosen the screws on the accumulator pole outlets.
Connect the red wire to the (+) pole of the accumulator and retighten the screw.
Connect the brown wire to the (–) pole of the accumulator and retighten the screw.
Reverse connection of the wires then stated above will result in a damage to the machine.
When disconnecting the accumulator, always disconnect the (–) pole as the fi rst.
Follow the instruction for the maintenance stated in the accumulator operating instructions.
WARNING
30