Slave Mode - afx light SPOT10LED Manuel D'utilisation

Pan Reverse
With this function you can reverse the Pan-movement.
- Select via the control board.
- Select Pan menu and select Yes to reverse Pan or No to stay in normal mode. After, press enter button to
validate your setup.
- Press the Mode/Esc-button in order return to the main menu
Tilt Reverse
With this function you can reverse the Tilt -movement.
- Select via the control board.
- Select Tilt menu and select Yes to reverse Tilt or No to stay in normal mode. After, press enter button to
validate your setup.
- Press the Mode/Esc-button in order return to the main menu
Display Reverse
With this function you can reverse the display-movement.
- Select via the control board.
- Select Disp menu and select Yes to reverse display or No to stay in normal mode. After, press enter button to
validate your setup.
- Press the Mode/Esc-button in order return to the main menu
Reset Default
With this function, you can select restore factory set for ON or OFF, the default is OFF.
Reset Motor
- Select via the control board.
- Select Rst and press enter button to reset motor position

SLAVE MODE

Up-to 32 units can be daisy chained together with one single unit acting as Master and all other linked units acting as
Slaves. Slave units will all run in sync with the master unit without the need for an additional controller. Connections
can be made using standard DMX control cables with Master unit running in Auto Run or Sound Activated Modes
and placed at the beginning of the chain
Selection of Slave Mode
Press the "MENU" button and choose "RUN". When the "ENTER" button is pressed, the LED display changes to
"SLAVE" and the unit will be slaved to control signals coming from a Master unit
©Copyright LOTRONIC 2015 SPOT10LED Page 6