Mercedes-Benz 172 584 38 00 Notice D'utilisation page 21

Displaying symbols for POIs
You can display POI symbols on the map.
Two categories are available:
standard POI symbols
R
personal POI symbols
R
You can select personal POI symbols via
COMAND using NaviQMap Set‐ Navi
tings tingsQPOI Symbols on Map POI Symbols on
The following commands are possible:
"Switch on POI symbols"
R
"Switch on standard POI symbols"
R
"Switch on personal POI symbols"
R
"Switch off POI symbols"
R
Example of dialog:
\ Switch on POI symbols
^ POI symbols are on. The display
depends on the map scale.
_ The system displays the symbols of the
previously selected category on the
map.
"Read out traffic messages"
You can use the "Read out traffic messages"
command to have traffic messages on your
currently planned route read out. However,
this is only possible if Real-Time Track Data
(RTTD) is available.
Entering an address
The system guides you through the dialog to
route guidance. As soon as a valid address is
entered, you can use the command "Start
route guidance" to start route guidance.
"Enter state"/"Enter province"
You can use the "Enter state"/"Enter prov-
ince" command to change the state or the
province set in the navigation system.
Map Set‐
Map.
Example of dialog:
\ Enter state
^ Please say the state.
\ Michigan
^ The data is being loaded.
_ The system shows a numbered list of
possible states on the display. If there
is only one entry in the list, the Voice
Control System asks if it is correct.
^ Please select a line number.
\ Number one
^ Number one accepted.
"Enter destination"
Using the "Enter destination" command, you
can enter the city, street and house number
of a destination.
The system guides you through the dialog. As
soon as a valid address is entered, the Voice
Control System asks whether you would like
to start route guidance.
Example of dialog:
\ Enter destination
^ Please say the house number, the
name of the street and the city.
\ 1 Main Street, Nanuet
^ Please wait.
^ 1 Main Street, Nanuet
Would you like to start route guidance?
\ Yes
^ Route guidance is started. The route is
calculated.
The system stores the selected destination
and starts route guidance.
i
If the Voice Control System fails to rec-
ognize your entry, it is advisable to spell the
name of the city and road.
"Enter city"
You can use the "Enter city" command to
enter all the cities of the state or province set.
Navigation
19
Z