Restrictions; General Information; Contact Address; Warranty - Burkert 8835 Manuel D'utilisation

▶ Installation and maintenance work may be carried out only by
authorized technicians with the appropriate tools.
▶ After an interruption in the electrical or pneumatic supply, ensure
that the process is restarted in a defined or controlled manner.
▶ The general rules of technology must be observed for applica-
tion planning and operation of the device.
NOTE!
Electrostatic sensitive components / modules.
The device contains electronic components which react sensitively
to electrostatic discharge (ESD). Contact with electrostatically
charged persons or objects are hazardous to these components.
In the worst case scenario, they will be destroyed immediately or
will fail after start-up.
▶ Observe the requirements in accordance with EN 61340-5-1 to
minimize or avoid the possibility of damage caused by a sudden
electrostatic discharge.
▶ Also ensure that you do not touch electronic components when
the power supply voltage is present.
3.1

Restrictions

If exporting the system/device, observe any existing restrictions.
6
english
Type 8835
Generalinformation
4

GENERAL INFORMATION

4.1

Contact address

Germany
Bürkert Fluid Control Systems
Sales Center
Christian-Bürkert-Str. 13-17
D-74653 Ingelfingen
Tel. + 49 (0) 7940 - 10 91 111
Fax + 49 (0) 7940 - 10 91 448
E-mail: info@de.buerkert.com
International
Contact addresses can be found on the final pages of the printed
operating instructions.
And also on the Internet at: www.burkert.com
4.2

Warranty

The warranty is only valid if the device is used as intended in accordance
with the specified application conditions.
4.3

Information on the Internet

The operating instructions and data sheets for the device can be found
on the Internet at: www.burkert.com