Rf5132 Software Default; Deleting Wireless Devices - DSC PowerSeries RF5132-433 Manuel D'installation

NOTE: For UL Listed installations, the RF Jam feature must be enabled - Section [804], subsection [90], Option [7]
OFF. Ensure the wireless bit is enabled and jam bit in section [90] is disabled.

4.5 RF5132 Software Default

Returning the RF5132 programming to factory default settings is a quick way to remove all the enrolled devices from
the system and reset all the programming in section [804].
NOTE: Performing this procedure will not change any programming sections except [804]. Resetting the control panel
to factory default settings will not return the RF5132 module to factory default settings.
To restore the RF5132 programming to the factory default settings:
1. Enter [*][8] [Installer's Code].
2. Enter programming section [996].
3. Enter the Installer's Code, followed by [996] again. The software for the RF5132 will be restored to its factory
default settings.
4. To continue programming the unit, exit installer's programming by pressing [#] and then re-enter installer's
programming by entering [*][8] [Installer's Code].
For instructions on restoring the default programming of the control panel or any other connected module, see your
system Installation Manual.

4.6 Deleting Wireless Devices

To remove a wireless device from the system, follow the guideline for enrolling a wireless device (see section 3.2).
Program the ESN as [000000]. The wireless device for the zone will be removed.
NOTE: You may need to remove power from the panel in order to clear troubles caused by deleted zones.
Now that you have completed all RF5132 related programming, you can test and mount the
receiver and devices. See section 5 for more information.
11