Tr5164 Software Default - DSC TR5164 Instructions D'installation

4.5 Program Wireless Key Function Buttons
Wireless keys have four or six programmable function buttons. Default functions have been assigned,
but other functions may be programmed if desired.
NOTE: 2-way wireless keys (WT4989) can only be assigned to partition 1.Wireless keys do not
work when the partition is being programmed or bypassed.
To program wireless key function buttons:
1. At a system keypad, enter [
2. Enter programming section [804].
3. Enter programming section [141] to [156] for wireless keys 1-16.
4. For each of the available buttons on the wireless key, enter the 2-digit number corresponding to the
selected function. See "Wireless Key Function Key Options" on page 18 for a list of function key
options.
5. Record all programming choices in the worksheets in the back of the manual.
6. To exit press [#].
For more information on programming wireless key function buttons, refer to the wireless key
installation sheet.

4.6 TR5164 Software Default

Returning the TR5164 programming to factory default settings removes all enrolled devices from the
system and resets programming in section [804].
NOTE: Performing this procedure does not reset any other programming sections on the control
panel. Likewise, resetting the control panel to factory defaults does not effect TR5164
programming.
To reset TR5164 programming to factory default settings:
1. Enter [ ][8] [Installer Code].
,
2. Enter programming section [996].
3. Enter the Installer Code, followed by [996] again. The software for the TR5164 is reset to factory
defaults.
4. To continue programming the unit, exit and then re-enter Installer Programming by pressing [#]
[ ][8] [Installer Code].
,
For instructions on resetting the control panel or any other connected module to factory defaults, see the
control panel installation manual.
][8][Installer Code].
,
10