Using The Flat Scrubber Accessory; Using The Steam Duster Accessory - shark S4701 Série Manuel Du Propriétaire

USING THE FLAT SCRUBBER ACCESSORY

Cleaning Tip: The Flat Scrubber Accessory is ideal for
a variety of surfaces. Its design allows you to apply more
force when scrubbing.
CAUTION: Make sure the Steam Mop is
unplugged or in Standby Mode while attaching
or removing the Flat Scrubber Accessory.
Avoid touching the Accessory, as it will be
very hot after steaming.
CAUTION: To avoid scalding injuries, always unplug
and allow the Steam Mop to cool before removing
or changing Accessories or Cleaning Pads.
CAUTION: Do not use on wallpaper.
1
To attach the Flat Scrubber Pad, place it exterior side
down on a flat surface, then set the Flat Scrubber
Accessory into the inside of it. Pull the Pad over the
edges of Accessory until it fits snuggly.
2
Attach the Flat Scrubber Accessory by connecting it
to the Direct Steam Nozzle until it clicks into place.
3
When you press the Steam Control Button Accessory
Mode (ACCESSORY) will automatically be selected
and you can begin cleaning (LO and HI Settings are
not available for above-floor cleaning).
4
To remove the Flat Scrubber Accessory, squeeze
the Accessory Release Buttons, then slide out the
Accessory.

USING THE STEAM DUSTER ACCESSORY

Cleaning Tip: The Steam Duster Accessory is ideal for
cleaning and dusting a variety of surfaces, like large areas,
hard-to-reach places, and crevices.
CAUTION: Make sure the Steam Mop is unplugged
or in Standby Mode while attaching or removing
the Steam Duster Accessory. Avoid touching the
Accessory, as it will be very hot after steaming.
CAUTION: To avoid scalding injuries, always unplug
and allow the Steam Mop to cool before removing
or changing Accessories or Cleaning Pads.
1
Slide the Steam Duster Pad all the way up the Steam
Duster Accessory so it fits snuggly.
2
Cinch the elastic band and slide the locking toggle to
tighten.
3
Attach the Steam Duster Accessory by connecting it
to the Direct Steam Nozzle until it clicks into place.
4
When you press the Steam Control Button Accessory
Mode (ACCESSORY) will automatically be selected
and you can begin cleaning (LO and HI Settings are
not available for above-floor cleaning).
5
To remove the Steam Duster Accessory, squeeze
the Accessory Release Buttons, then slide out the
Accessory.
www.sharkclean.com
EN
18