Frequently Asked Questions - shark S4701 Série Manuel Du Propriétaire

Frequently Asked Questions

QUESTION
How do I deploy the Stain
Scrubber?
How do I retract the Stain
Scrubber?
Is the Stain Scrubber going to
damage my floors?
What surfaces can I use the
Steam Mop on?
Can I put something other than
water in the Water Tank of the
Steam Mop?
How do I convert to the Hand-
held Steamer for Above-Floor
Cleaning?
Can I steam soft surfaces and
fabrics with the Above-Floor
Accessories?
Which Steam Setting should
I use with the Above-Floor
Accessories?
25 1-800-798-7398
ANSWER
To deploy the Stain Scrubber, slide the Engage Scrubber/Release Head Button
all the way down until you hear a click. The Stain Scrubber will automatically
pop into position. Lift the Mop Body off the Mop Head and place it on the floor
to start scrubbing.
Re-dock the Mop Body onto the Mop Head and the Stain Scrubber will
automatically retract.
The Stain Scrubber is designed to be safe on all sealed floors, but it is always
recommended to test an isolated area of the surface to be cleaned before
proceeding.
The Steam Mop is designed for use on all sealed hard-floor surfaces. We
recommend that you first test an isolated area of the floor surface to be cleaned
as well as review the use and care instructions from your floor manufacturer.
WARNING: Do not use on leather, wax-polished furniture, synthetic
fabrics, velvet, or other delicate, steam-sensitive materials.
NOTE: On surfaces treated with wax and on some no-wax floors, the sheen
may be removed by the heat or steam action of the unit. Test an isolated area of
flooring first to see if sheen is affected.
DO NOT add cleaning solutions, scented perfumes, oils, or any other chemicals
to the water used in this appliance as this may damage the unit or make it
unsafe for use. We recommend using distilled water in your Steam Mop.
Remove the Mop Handle by pressing and holding down the Handle Release
Button while pulling the Mop Handle out of the Mop Body. Press down the Engage
Scrubber/Release Head Button and lift the unit off the Mop Head. Attach the
Accessory Hose by snapping it into the Steam Nozzle of the Handheld Steamer.
No, Above-Floor Accessories are designed to clean hard surfaces only.
Once you transition to the Handheld Steamer, the unit will only be able to select
the ACCESSORY Setting. You will not be able to select the LO or HI Settings.