Using Your Steam Mop - shark S4701 Série Manuel Du Propriétaire

Using Your Steam Mop

IMPORTANT: Make sure you do not use the Steam Mop without attaching a Pocket Pad and adding water
to the Water Tank first. When you are using the Steam Mop for the first time, it might take longer than
the normal 30 seconds to start steaming.
IMPORTANT: Do not use on unsealed wood or unglazed ceramic floors. On surfaces that have been treated
with wax and on some no-wax floors, the sheen may be removed by the heat and steam action. Test an
isolated area of the surface to be cleaned before proceeding. Check the use and care instructions from the
floor manufacturer.
fig. 6
NOTE: To prolong the life of your Steam Mop, we
recommend using distilled water.
NOTE: Sweep or vacuum your floors prior to
cleaning with your Steam Mop.
1
Pull and twist the Quick-Release Cord Holder to
unwrap the power cord completely (fig. 6). Plug into
an electrical outlet.
2
The Steam Mop will be in Standby Mode as soon as it
is plugged in. The Standby Mode can be identified by a
blinking light around the Steam Control Button (fig. 7).
3 Press the Steam Control Button to select either the LO or
HI Setting (the ACCESSORY Setting is not available for
floor cleaning) (fig. 7). Press once for the low setting, twice
for HI, and three times to return to Standby Mode. Once in
Standby Mode, a light will blink around the Steam Control
Button, but all other Steam Setting Lights will be off.
4
Clean your floors with a forward and backward motion.
5
When you come to a tough, dried-on floor stain, use
the Steam Blast Scrub Mode to clean it away.
fig. 7
6
To engage the Steam Blast Scrub Mode, slide the
Engage Scrubber/Release Head Button all the
way down until you hear a click (fig. 8). The Stain
Scrubber will automatically pop into position. Lift
the Mop Body off the Mop Head and place the Stain
Scrubber on the floor to start scrubbing.
CAUTION: While in Scrub Blast Mode, do not
leave the Steam Mop stationary.
CAUTION: Do not Scrub any one area for an
extended period of time.
7
To go back to mopping, re-dock the Mop Body onto
the Mop Head. The Stain Scrubber will automatically
retract.
8
When you are done mopping, press the Steam
Control Button until you return to Standby Mode.
9
When the Water Tank is empty, the Steam Mop will stop
producing steam. You can refill the Water Tank at any
time as long as the Steam Mop is unplugged. Follow the
Water Tank filling instructions on page 11.
NOTE: Please wait 2 to 3 minutes for the Steam
Mop to cool off before switching the Mop Head or
Cleaning Pad. Never leave the Steam Mop with a
damp/wet Cleaning Pad on any floor.
fig. 8
www.sharkclean.com
EN
12