Emptying The Dust Cup; Important - shark Navigator Lift-Away Zero-M Speed ZU560 Série Guide D'utilisation

EMPTYING THE DUST CUP

IMPORTANT: Unplug the power cord before performing any maintenance.
To remove Dust Cup, lift tabs on both sides of
dust cup handle. Tilt dust cup forward, then
lift to remove.
To remove collected debris from Lint Screen,
press top release button and lift handle to
open. Gently brush lint screen to clean.
s h a r kc l e a n . c o m
Press lower release button to open bottom of
dust cup.
To reinstall, place bottom of dust cup into
pod and then tilt back until it clicks into place.
CLEANING AND REPLACING THE FILTERS
CLEANING FILTERS
Regularly clean and replace your filters to keep your vacuum's suction power optimal.
To clean filters, rinse with cold water only to prevent damage from cleaning chemicals. Allow all
filters to air-dry for at least 24 hours before reinstalling them to prevent liquid from being drawn
into electric parts.
IMPORTANT: DO NOT use soap when cleaning the filters.
CLEAN PRE-MOTOR FILTERS
EVERY 3 MONTHS
Remove Dust Cup, then lift out Filters.
Filter
Door
CLEAN HEPA FILTER
EVERY YEAR
Press button at bottom of Filter Door. Tilt
Filter Door and lift out. Remove HEPA Filter.
To reinstall, insert HEPA filter into unit and
replace the filter door.
s h a r kc l e a n . c o m