Storage; Tips; Home-Made Chips - SilverCrest SEF3 2000 A1 Mode D'emploi

GB
IE

Storage

Tips

Home-made chips

14
■ Clean the appliance lid in warm water using a mild detergent. Rinse the
appliance lid off with clear water.
Dry the appliance lid well and then place it upright on its side so that any
excess water still inside the lid can drain away.
Be aware that the lid must be completely dry before re-use!
3) Dry all parts well before reassembly.
1) Lift or carry the appliance using the side handles on the housing.
2) Wind the cable around the cable spool 6 on the rear of the appliance and
fasten it with the cable clip.
3) Store the appliance with the appliance lid closed. This will keep the inside
of the deep fat fryer clean and free of dust.
■ Potatoes intended for frying should be in good condition and not germinating.
■ Use potato varieties that are suitable for frying, such as those that are
"fl oury" or "primarily waxy".
■ After peeling, cut the potatoes according to the intended preparation (chips
or wedges).
■ Soak the potatoes for about one hour prior to use. This will help remove part
of the sugar content, which is one of the constituent products for the formation
of acrylamide.
■ Carefully dry the potatoes.
■ Always fry home-made potatoes twice:
–
fi rst for 10–14 minutes at 150 °C then for 3–4 minutes at 170 °C,
depending on the desired degree of browning.
■ Deep-frozen chips are pre-cooked and thus only need to be fried once.
Comply with the instructions on the packaging.
SEF3 2000 A1