Stihl MS 260 Notice D'emploi page 40

: Pull the starter grip slowly with your
right hand until you feel it engage –
then give the grip a brisk strong pull
and push down the front handle at
the same time.
Do not pull out the starter rope to its full
length – it might otherwise break.
Do not let the starter grip snap back –
guide it slowly into the housing so that
the starter rope can rewind properly.
If the engine is new, pull the starter
several times to prime the fuel line.
MS 260
STOP
0
6
4
5
When engine begins to fire:
: Move Master Control lever (4) to n
and continue cranking – as soon
as engine runs, immediately blip
the throttle trigger (5) –
the Master Control lever (4) will
move to the "Run" position # (6)
and the engine will settle down to
idling speed.
.
As the chain brake is still engaged,
the engine must be returned to
idling speed immediately – or the
engine and chain brake might
otherwise be damaged.
: Pull the hand guard back toward
the front handle:=
The chain brake is now disengaged
– your saw is ready for operation.
Always disengage chain brake
before accelerating engine. High
revs with the chain brake engaged
(chain locked) will quickly damage
the powerhead and chain drive
(clutch, chain brake).
: Observe safety precautions.
: Always check operation of chain
lubrication before starting work.
English
39