Use Of Rinse Aid - Progress PV 1530 Notice D'utilisation

4. Replace the cap making sure that there
is no trace of salt on the screw thread or
on the gasket.

Use of rinse aid

Warning! Only use branded rinse aid for
dishwashers.
Never fill the rinse aid dispenser with any
other substances (e.g. dishwasher
cleaning agent, liquid detergent). This
would damage the appliance.
Rinse aid ensures thorough rinsing, and
spot and streak free drying.
Rinse aid is automatically added during
the last rinse.
1. Open the container by pressing the re-
lease button (A).
2. Add the rinse aid in the container. The
maximum level for filling is indicated by
"max".
5. Replace the cap tightly turning it clock-
wise until it stops with a click.
Do not worry if water overflows from the
unit when filling with salt, this is quite
normal.
The salt indicator light on the control
panel can remain illuminated for 2-6
hours after the salt has been replen-
ished, assuming the dishwasher re-
mains switched on. If you are using
salt that takes longer to dissolve
then this can take longer. The oper-
ation of the machine is not affected.
The dispenser holds about 110 ml of rinse
aid, which is sufficient for between 16 and
40 washing cycles, depending upon the
dosage setting.
3. Ensure that the lid is closed after every
refill.
Clean up any rinse aid spilt during filling
with an absorbent cloth to avoid excess
foaming during the next wash.
According to the finish and drying results ob-
tained, adjust the dose of rinse aid by means
of the 6 position selector (position 1 minimum
dosage, position 6 maximum dosage).
The dose is factory set in position 4.
Increase the dose if there are drops of water
or lime spots on the dishes after washing.
progress 71