Progress PV 1530 Notice D'utilisation page 75

Please observe the manufacturer's dos-
ing and storage recommendations as
stated on the detergent packaging.
Using no more than the correct amount
of detergent contributes to reducing pol-
lution.
Fill with detergent
1. Open the lid.
2. Fill the detergent dispenser (1) with de-
tergent. The marking indicates the dosing
levels:
20 = approximately 20 g of detergent
30 = approximately 30 g of detergent.
2
3. All programmes with prewash need an
additional detergent dose (5/10 g) that
must be placed in the prewash detergent
chamber (2).
This detergent will be used during the
prewash phase.
When using detergent tablets; place the
tablet in compartment (1)
1
4. Close the lid and press until it locks in
place.
Detergent tablets from different manu-
facturers dissolve at different rates. For
this reason, some detergent tablets do
not attain their full cleaning power during
short washing programmes. Therefore,
please use long washing programmes
when using detergent tablets, to ensure
the complete removal of detergent re-
siduals.
Use of combi detergent tablets
These products are detergents with a com-
bined cleaning, rinsing and salt functions.
They can also contain other different agents
depending on which kind of tablets you
choose ('3 in 1', '4 in 1', '5 in 1'etc.).
1. Check whether these detergents are suit-
able for your water hardness. See the
manufacturers instructions.
The refilling of the salt container and the
rinse aid dispenser are no longer neces-
sary.
2. Select the lowest setting for water hard-
ness and rinse aid dosage.
If the drying results are not satisfactory
we recommend that you:
1. Fill up the rinse aid dispenser with rinse
aid.
2. Set the rinse aid dosage to position 2.
If you decide to turn back to the use of
standard detergent system we advise
that you:
1. Fill up the dispensers for salt and rinse aid
again.
2. Adjust the water hardness setting to the
highest setting and perform 1 normal
progress 75