Shindaiwa T350 Manuel D'utilisation page 19

1. Cutting attachment
shield
2. Hook receiver
Installing a nylon line cutting head
1. Shaft bolt (not used)
2. Bolt guard (not used)
3. Holder B
1. L-wrench
3. Sub-shield
4. Hook
4. Safety clip (not used)
5. Holder A
6. Gearcase shaft
Before you start
1. Attach the shield extension to the cutting attachment shield.
Never use this product without sub-shield when using a
trimmer head.
Make sure the sub-shield is completely hooked at the
hook receiver.
NOTE
This product is shipped with Holder A, the blade retainer (safe-
ty clip), Holder B, shaft bolt, and bolt guard installed. The shaft
bolt is a LEFT-HAND thread. Remove it by turning CLOCK-
WISE!.
1. With the gearcase output shaft facing up, rotate the output
shaft and Holder A until the hole in Holder A aligns with the
matching hole in the gearcase flange, and then lock the hold-
er to the gearcase by inserting the long end of the L- wrench
through both holes.
2. Using the socket wrench, remove the shaft bolt, bolt guard,
Holder B and the safety clip. (The bolt guard, shaft bolt and
safety clip are not used with a trimmer head).
3. Install Holder B on the gearcase shaft. The splined hole on
Holder B must engage with the gearcase shaft.
4. Using the L-wrench to secure Holder A, install and hand-
tighten the trimmer head (counter-clockwise to install).
5. Remove the L-wrench from the gearcase and holder.
17
WARNING
CAUTION