Before You Start; Assembly; Loop Handle Version - Shindaiwa T225S Manuel D'utilisation

Before you start

Assembly

Read the operator's manual carefully to ensure that you assemble the product correctly.
Using a product that has been incorrectly assembled could lead to an accident or serious injury.

Loop handle version

1. Loop handle
2. Screw M5×35
3. Loop handle bracket
1. Shield
1. Blade retainer fixing slot
2. Blade retainer
WARNING
4. Nut
5. To engine
2. Bolt
3. Nylon line cutting head
Before you start
Loop handle assembly
Assemble loop handle and bracket to drive shaft assembly.
Position handle in comfortable operating position and tighten
screws (M5×35).
Install the handle so that it does not hide any of the
safety decals.
Installation of shield
Fit shield to mounting portion of angle transmission and tighten 4
bolts.
Installing nylon line cutting head
Use only flexible, non-metallic line recommended by
YAMABIKO CORPORATION.
Fasten output shaft using locking tool securely in order
to avoid the possibility of output shaft rotating when
mounting nylon line cutting head.
Insert locking tool into a hole located on the right side of angle
transmission while forcing retainer spring to the left side. Insert
locking tool further into blade retainer fixing slot to fix output shaft.
18
CAUTION
CAUTION