Shindaiwa T350 Manuel D'utilisation page 18

Before you start
1. Band
1. Throttle cable
2. Cable cap
Cutting attachment shield assembly
1. Socket-head cap
Screw
2. Bracket
3. Shim
4. Clamp screw
5. Outer tube
3. Adjusting nut
4. Lock nut
6. Cutting attachment
shield
7. Shim
8. Cutting attachment
shield mounting plate
9. Retaining nut
4. Secure the cable to the outer pipe with the two bands as the
illustration shows. The two bands are in the tool bag.
Adjust throttle lever free play
1. Pull the throttle trigger gently, and check for free-play of ap-
proximately 5mm.
2. If free-play is out of specifications:
(1) Slide the cable cap toward the silencer side until the ad-
justing nut and the lock nut appear.
(2) Loosen the lock nut slightly.
(3) Turn the adjusting nut so that free-play is about 5mm.
(4) Then, tighten the lock nut.
(5) Slide the cable cap back.
Cutting Attachment Shield
1. Insert the cutting attachment shield between the outer tube
and the cutting attachment shield mounting plate.
NOTE
It may be necessary to loosen the retaining nut and clamp
screw to adjust cutting attachment shield mounting plate.
2. Fit the two shims and the bracket over the outer tube and
loosely install the four socket-head cap screws.
3. Tighten the four socket-head cap screws to secure the cut-
ting attachment shield.
Make sure the clamp screw and retaining nut are securely
tightened before tightening the four socket-head cap
screws.
Sub-shield (when trimmer head is in use) (Consult
your dealer.)
16
CAUTION