Lighting The Grill - BORETTI IBRIDO Notice D'emploi

Lighting the Grill

DO NOT ATTEMPT TO "LIGHT" THE GRILL IF THE ODOR OF GAS IS PRESENT!
Before and after lighting
1 Ensure your grill is located on a level surface.
2 Keep the gas grill area clean and free from combustion materials, gasoline, and other flammable vapors
and liquids.
3 Ensure nothing is obstructing the flow of combustion and ventilation air.
4 Ensure the ventilation of the cylinder enclosure are free and lear of debris.
5 Visually check burner flames.
WARNING: Check the gas supply line for cuts, wear or abrasion. Always keep your face and body as far away
from the grill as possible when lighting.
Grill burner lighting
Lighting the Grill with Electronic Igniter
1 Make sure all control knobs are in the "OFF" position
2 Open the gas supply valve located on top of your L.P. tank
ATTENTION: When turning the L.P. tank on, make sure to open the
valve very SLOWLY two (2) complete turns to ensure proper gas
flow.
3 Always open the hood before attempting to light.
4 Push and turn one of the control knobs counter-clockwise to the
"HIGH" position and immediately press the electronic igniter
button.You will hear a snapping sound. It may be necessary to
hold the electronic starter button for about 4 seconds. (See Fig. 4)
NOTE: If the burner does not light in 4 seconds, turn the knob to the "OFF" position and wait 5 minutes before
trying again.
5 Repeat above steps to light remaining burners.
Match lighting
If by chance the electronic igniter does not light the burner, the burner
may be lit with a match attached to the match extender, located on the
inside of the cart door. Keep your face as far away from the grill surface
as possible and pass the match extender through the spaces in the grill
grates to the ports of the back crossover burner between the flavor
grids. Position the match near the burner ports and push and turn
the control knob counter-clockwise to the "HIGH" position. (See Fig. 5)
The match extender can be stored inside the cart door by sliding the
extender ring through the opening on the inside, back of the cart door.
(See Fig. 6).
NOTE: If the grill will not light after several attempts see the trouble-
shooting section of this manual. Turn the control knobs to the OFF
position when not in use. Keep any electrical supply cords and the fuel
supply away from any heated surfaces.
80
Fig. 4
Fig. 5
Fig. 6