Warranty - Flotec FP0F360AC Notice D'utilisation

Safety
READ AND FOLLOW
SAFETY INSTRUCTIONS!
This is the safety alert symbol. When you see this
symbol on your pump or in this manual, look for
one of the following signal words and be alert to the
potential for personal injury!
DANGER warns about hazards that will
cause serious personal injury, death or
major property damage if ignored.
WARNING warns about hazards that can
cause serious personal injury, death or
major property damage if ignored.
CAUTION warns about hazards that will
or can cause minor personal injury or
property damage if ignored.
The word NOTICE indicates special instructions which
are important but not related to hazards.
Carefully read and follow all safety instructions in this
manual and on pump.
Keep safety labels in good condition.
Replace missing or damaged safety labels.
California Proposition 65 Warning
This product and related accessories contain
chemicals known to the State of California to cause can-
cer, birth defects or other reproductive harm.
ELECTRICAL SAFETY
WARNING
and motor nameplate.
Canadian Electrical Code,
Hazardous voltage. Can
and local codes for all
shock, burn, or cause
death.
wiring.
Ground pump before con-
necting to power supply.
Disconnect power before
working on pump, motor
manual when connecting
or tank.
motor to power lines.
Make workshops childproof; use padlocks and master
switches; remove starter keys.
For parts or assistance, call Flotec Customer Service at
Wire motor for correct
voltage. See "Electrical"
section of this manual
Ground motor before
connecting to power
supply.
Meet National
Electrical Code,
Follow wiring
instructions in this
Capacitor voltage may be hazardous. To
discharge motor capacitor, hold insulated
handle screwdriver BY THE HANDLE and short capacitor
terminals together. Do not touch metal screwdriver blade
or capacitor terminals. If in doubt, consult a qualified
electrician.
GENERAL INFORMATION
Do not allow pump or any system component to freeze.
To do so will void warranty.
Pump water only with this pump.
Periodically inspect pump and system components.
Wear safety glasses at all times when working on pumps.
Keep work area clean, uncluttered and properly lighted;
store properly all unused tools and equipment.
Keep visitors at a safe distance from the work areas.
To avoid over pressure hazard and possible injury, install
pressure relief valve capable of passing full pump flow
at 75 PSI (517kPa). Pressurized suction may cause pump
body to explode.
Do not touch an operating motor. Modern
motors are designed to operate at high
temperatures. To avoid burns when servicing pump,
allow it to cool for 20 minutes after shut-down before
handling.
1-800-365-6832
3
WARNING
Hazardous pressure!
Install pressure relief
valve in discharge pipe.
Release all pressure on
system before working on
any component.