Adjusting The Tracking Of The Front Caster - Titan PowrLiner PL4950 Mode D'emploi

Maintenance
6. Place the spring (9) on the brush (6) as shown above. Push
in and hook the spring clip (2). Repeat this procedure for the
other side.
8
7
7. Reinstall both inspection covers.
If electric motor overloads and stops running,
IMMEDIATELy turn the motor off and follow
the Pressure Relief Procedure in the Cleanup
section of this manual. Wait until the motor cools
(approximately 30 minutes). Then push in the
bubble top, manual reset button, turn the motor on
and pressurize the system.
6
9
2
GB
6.7

Adjusting the Tracking of the Front Caster

The front caster is set by the factory to track in a straight line. Use the
following procedure if adjustment the caster becomes necessary.
1. Loosen the two hex screws (1) in the top of the caster
mounting bracket (2).
2. Turn the caster mounting bracket (2) slightly in the desired
direction.
i
The front caster locking pin must be engaged during
tracking adjustment.
3. Tighten the two hex screws (1).
4. Check the tracking of the front caster (3). If the caster does not
track straight, repeat the above procedure.
2
1
3
16 PowrLiner