Preparing The Device For Use; Assembly; Spray Nozzle, Filter Element And Filling Strainer - Solo 425 Classic Instructions D'emploi

Masquer les pouces Voir aussi pour 425 Classic:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 32

3 Preparing the device for use

3.1 Assembly

The backpack sprayer is dismantled before it is
dispatched. It must be fully reassembled again
before it is used.
Fig. 1
Month/year of production
( schematic diagram / depending on the model )
The pump lever (c) can be attached to either side
of the device.
Installation of the pump lever:
See "Assembly Instruction of the pump lever"
Safety clips (a) with 473D Classic and
475 Classic:
The backpack sprayer is prepared at the factory for
left-hand side installation of the pump lever (facing
towards the tank inscription, Fig. 1).
If you prefer the pump lever to be mounted on the
other side, reposition the safety clips (a) on the
opposite side.
Installation of the spray tube:
x Fasten the threaded collar (e) on straight and
firmly screw the spray tube with O-ring
(16x3 mm) hand-tight onto the shut-off valve.
Do not use any tools!
x Firmly screw the nozzle attachment (h) with the
O-Ring (10x2 mm) hand-tight onto the spray
tube. Do not use any tools!
x When your work is completed, the spray tube
should be fitted into both holding clips (d).
Installation of the pressure gauge (Accessories
part no.: 49 00 356):
x Unscrew the black threaded collar from the
shut-off valve.
x Screw the black threaded collar of the pressure
gauge accessory kit onto the shut-off valve.
x Insert the O-ring into the threaded collar and
a
(only for
screw the pressure gauge hand-tight into the
473D Classic,
threaded collar. Do not use any tools!
475 Classic)
3.2 Spray nozzle, filter element and
A red flat jet nozzle 04-F110 is pre-assembled as
the standard spray nozzle.
Delivery rate: See section 10
A filter element is fitted in the elbow piece
upstream of the spray nozzle (Fig. 2, mesh
aperture: 0.8 mm [0.031"], part no.: 40 74 922 25).
The backpack sprayer is equipped with a filling
strainer located in the filler neck of the spraying
agent tank (mesh aperture: 2.0 mm [0.079"], part
no.: 42 00 166 25).
Only the spray nozzles listed in section 10, the
above mentioned genuine filter element and filling
strainer must be used in this backpack sprayer.
Changing spray nozzles and filter element:
See section 6.3
3 Preparing the device for use
filling strainer
Fig. 2
ENGLISH 7

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

473d classic475 classic

Table des Matières