Cleaning And General Maintenance Guidelines - Redmond RMC-M90FR Manuel D'utilisation

V. CLEANING AND GENERAL MAINTENANCE GUIDELINES
Before you start cleaning the device, make sure that it is unplugged and has cooled down. Use soft cloth and mild soap to clean. We recommend
cleaning the appliance after each use.
Prior to first use or in order to remove the odor steam half a lemon for 15 minutes using "VAPEUR" program.
Do not use a sponge with hard or abrasive surface; solvent and abrasive cleaning methods (gasoline, acetone) are not allowed. Do not immerse the device
in water or wash it under running water.
Steam valve, inner aluminum lid, and the bowl need to be cleaned after each use. The bowl is dishwasher safe. By the end of cleaning, wipe the bowl
dry.
To clean the inner lid:
1. Open the lid.
2. Press 2 plastic holders on the inner side of the lid pointing towards the center until open.
3. Gently pull the inner lid towards yourself and down to get it separated from the main lid.
4. Wipe the surfaces of both lids with wet cloth or tissue. Wash under running water, using mild soap if needed. Not dishwasher safe.
5. Carry out the assembly in return sequence: slide the inner lid into upper groves overlapping it with the main lid. Gently push the holders until
they click into place. Make sure that the inner lid fits tightly.
The steam valve is located on the top lid of the device and consists of two parts: the cover and the main part. To clean the steam valve:
1. Take the cover of the steam valve off by pulling it gently up and towards yourself as shown A4
2. Inside the removed cover, turn the main part of the steam valve anticlockwise (in direction of
3. Take the rubber sealing ring out; wash all parts of the steam valve following cleaning and general maintenance guidelines provided.
CAUTION! Do not twist or stretch the rubber sealing ring to avoid its deformation.
4. Carry out the assembly of the steam valve in return sequence: place the rubber sealing ring back into the holder; overlap the groves of the
main part of the valve with the corresponding ledges on the inside of the cover and turn the valve clockwise in direction of
the steam valve back into the lid of the device, with the extraction ledge facing the back.
Condensation may accumulate in the special cavity around the bowl and in condensation container at the back of the device.
1. Open the device and take the bowl out. Lift the front side of the device if needed, to let the condensate flow down into the container.
2. Pull container towards yourself to remove.
3. Pour condensate out. Rinse the container and put it back into place.
4. Remove condensate remaining in the cavity around the bowl using cloth or tissue.
46
<open>
) to remove.
<close>
. Install