Publicité
Les langues disponibles
Les langues disponibles
05b. Thread the octagonal crown over the motor tube and push it, as far
as the motor head (fig. 8a). Important – slide the crown groove into
the protrusion found on the bushing of the limit switches.
8a
05c. Fit the drive wheel to the self-locking mechanism on the motor shaft,
by matching up the two arrows on the two devices (fig. 8b). Note
- if you wish to disconnect the wheel, press the "Push" button and
extract it.
8b
s h
P u
• Measure the motor as shown in fig. 8c.
8c
05d. (fig. 9) Align the adapter groove (a), with that on the drive wheel (b).
Then insert the motor into the roller tube, by sliding the two grooves
a and b in relation to the protrusion (c) found inside the roller tube.
9
05e. (fig. 9a) Screw the supplied screw into the tube (self-tapping 3.9 x
13, UNI 8118) at the point where the drive wheel is located inside
the tube (use the measurement carried out in fig. 8c). This step ena-
bles the wheel to be correctly locked with the tube.
Caution! - To determine the exact point to place the screw,
measure as shown below.
9a
XX
06. At the other end, insert the telescopic cap into the tube (fig. 10). Dur-
ing the operation, align groove (d) found on the cap with the groove
(c) found inside of the roller tube.
10
07. Fit the roller on to the pivot of the telescopic cap (fig. 11).
11
08. The tube is now ready to be installed in the case. Caution! – Before
continuing, ensure that the shutter is fully within the edge
guides and that the shutter is completely lowered.
09. Choose the side on which to position the motor head. – For
safety reasons, the motor head and power cable must be positioned
on the side on which the mains power supply is located (fig. 13).
10. Fix the support intended for the telescopic cap (fig. 12a) and
the motor head (fig. 12b), to the position determined in point 02
(fig. 6). Screws not supplied.
Caution! – When cutting, ensure that the tube profiles are not
deformed at their extremities.
11. Install the tube (with the motor) on the supports as follows:
a) – insert the square pivot into the support (fig. 13a);
English – 6
Publicité
