Cleaning And Sterilisation - Medela Basic 30 Mode D'emploi

Troubleshooting
XlII
Motor not running
Insufficient vacuum
If the fault cannot be rectified, please contact the internal technical department.

Cleaning and sterilisation

XlV
After each use, the parts that had been in contact with the aspirated secretions are to be
cleaned, disinfected, sterilised or disposed of. Before cleaning the device, pull the plug out of
the mains socket.
General notes
• The internal hospital guidelines take precedence.
• Disconnect the Basic 30 from the mains before cleaning / disinfection.
• Clean the device with a moist cloth and non-abrasive agents.
• Suction jar, lid, disposable liner and other accessories are to be treated in accordance with
the supplied instruction sheets.
• Wear protective gloves for cleaning / disinfection.
• Dispose of fluids such as blood and secretions and the parts contaminated with them
in accordance with internal hospital guidelines.
• Empty the jar or dispose of liner regularly.
• Detailed information according to Medela cleaning instructions 200.2391.
Medela recommends the following surface cleaning agents
Disinfecting Active ingredients
agent
Hexaquart plus Didecyldimethylammonium chloride
(aldehyde-free) Lauryl dipropylene triamine
[concentrate] Biguanidine acetate
Perform Potassium peroxomonosulphate
[concentrate] Sodium benzoate
Tartaric acid
Non-anionic surfactants
Soap phosphate
Perfumes
Check
• Mains voltage
• Switched on
• Fuse
Check
• Regulator setting
• Tubing
• Plug-in connections
• Overflow protection
• Suction jar and lid
(cracks, brittle areas, discolouration)
• Disposable system
(cracks, brittle areas, discolouration)
Amount in
100g
6 g
5.5 g
4.2 g
20 g
15 g
10 g
5 – 15%
5 – 15%
< 5%
Manufacturer
B. Braun Medical AG
www.bbraun.ch
Schülke & Mayr
www.schuelkemayr.com
EN 11