Hendi 231852 Mode D'emploi page 6

4.3. DISCS – STANDARD EQUIPMENT
Shredding discs
Slicing discs
4.4. USING THE DISCS
The device is supplied with the ejector fitted to the
drive spindle. Release the cover lock and lift the cov-
er to remove the ejector (see figure. 1)
Before starting work always check the cleanliness
of the cutting chamber, the drive spindle, the ejector
and the cutting discs.
1) Slicing, shredding and grating
• Mount the ejector onto the flat surface of the drive
spindle.
• Mount the required disc (slicing, shredding or other
– options.
EN
- Turn the dics clockwise to insert the bayonet and
keep on turning closwise until it reaches the pin.
5. CLEANING AND MAINTENANCE OPERATIONS
5.1. GENERAL INFORMATION AND PRODUCTS USED FOR CLEANING
Before carrying out any cleaning or maintenance
operations, check if the mains switch is off and the
plug is disconnected from the mains.
Clean the device and the discs thoroughly every day
to ensure correct operation and long life of the de-
vice.
The cutting discs and the ejector can be cleaned
with a warm water jet.
Clean the device, in particular the disc assembly,
only with a cloth or a sponge damped in warm water.
Thoroughly remove all remaining foodstuff to pre-
vent the discs from changing their position.
Open the cover and loosen pin 1 as shown in figure
no.3. Remove the cover and wash with warm run-
ning water.
Clean the surfaces with water with soap, alcohol,
non-abrasive detergents or with water without chlo-
rine- or soda-based substances (chlorinated water,
hydrochloric acid).
6
PICTURE
- To remove the disc, turn it in the opposite direction
and lift it using the finger holes at the edges of the
disc.
- Close and lock the cover.
2) Cutting into chips or cubes (option)
• Mount the ejector.
• Mount the chips/dice disc in the housing and check
for correct fixing (the assembly area must be cle-
an). The upper edge of the chips/dice disc must
be placed slightly below the top of the body of the
device.
• Then mount the slicing disc of the same size as the
chips/dice disc and close the cover.
Never use abrasives, steel wool or similar products
as they may damage the surface, coating or body of
the device.
For cleaning use non-toxic hygiene products.
PART NO.
280300
280416
280317
280102 2mm (3 blades)
280126 4mm (2 blades)
figure no. 3
SIZE
3mm
5mm
7mm