Hendi 231852 Mode D'emploi page 5

3.3. SAFETY MEASURES AND END USER TRAINING
Skilled personnel in charge of the installation and
electrical connections of the device shall be respon-
sible for training end users. Safety measures to be
4. DEVICE OPERATION
4.1. CONTROLS
The controls and pilot light are located on the top of
the device in the middle of the alumilium base.
1. Green start push button
2. Red stop push button
4.2. ASSEMBLING THE DISCS
Lift up the locking handle as shown in figure no. 1
And open the cover. Remove the ejector and place
appropriate disc. Close the cover. Push the start
Opening the cover (figure no. 1)
SINGLE-PHASE CONNECTION
applied should be communicated to end users. This
operation manual is supplied together with each de-
vice.
button to automatically hook the discs in the correct
position.
BE CAREFULL WITH THE DISC BLADES!
Disc position (figure no. 2)
EN
5