Extending/Lowering The Mast - Atlas Copco HiLight E2 Manuel D'instructions

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 75
3. To set the inclination angle of the floodlights,
loosen the adjustable hand lever (3). Put the
floodlight into the desired position and tighten the
adjustable hand lever again.
Carefully tighten the adjustable
hand lever after adjusting the
inclination of the floodlights to avoid
any unexpected inclination.
4. Proceed with extending the mast as described
below.
4.2.2

Extending/lowering the mast

1. Check whether the plastic spacers on top of the
mast sections (1) are in good condition. Replace if
necessary.
3
- 26 -
2. Use the winch to manually raise/lower the mast to
the desired height. The mast can be extended up to
the red indication on the first mast segment (2)
(max 6.9 metres).
1
1
2
1
1
Do not extend the mast at a wind
speed stronger than 80 km/h.
Mind your head while lowering the
mast!
When lowering the mast, check that
the power cord on the mast (spiral
cable (3)) collapses freely into its
holder and does not become pinched
or tangled!
3

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Hilight e3+Hilight esf

Table des Matières