Control And Indicator Panel For Hilight E2/E3+ Mod 03-04- 05-08-09; Available Models - Atlas Copco HiLight E2 Manuel D'instructions

2.4.2 Control and indicator panel for
HiLight E2/E3+ MOD 03-04-05-
08-09
Overview of the control panel
To operate the light tower a control panel is installed.
Q2-5
Q1 P8 P7
X1
S20
P7........ Photocell (optional)
P8........ Timer (optional)
Q1 ....... General circuit breaker
Interrupts the power supply when a short-
circuit occurs at the load side, or when the
overcurrent protection is activated. It allows
to isolate the machine.
Q2-5.... Circuit breakers for lamps
The control panel provides 4 circuit breakers
for the lamps (one for each lamp).
S20 ..... REMOTE/ON/OFF switch (optional)
The S20 switch only applies in models with
Timer and Photocell option installed.
Following positions can be selected:
MAN.: ON, for manual switch on
O: OFF, to disconnect
AUTO.: REMOTE START, for Auto
Photocell and weekly timer start
option. Connection in series of
both devices.
TIM.: REMOTE START, for weekly
timer start option.
PHOTO.: REMOTE START, for Auto
Photocell start option.
X1 ....... Inlet plug for connection to the mains
(Cable + SCHUKO plug, 10A, 2PH+PE)
- 18 -
2.5

Available models

There are 11 HiLight E2 and E3+ models available
(MOD 01-11):
– MOD 01: HiLight E2
– MOD 02: HiLight E2 TMR
– MOD 03: HiLight E2 SKT
– MOD 04: HiLight E2 SKT TMR
– MOD 05: HiLight E2 250 SKT TMR
– MOD 06: HiLight E3+
– MOD 07: HiLight E3+ TMR
– MOD 08: HiLight E3+ SKT
– MOD 09: HiLight E3+ SKT TMR
– MOD 10: HiLight E3+ 110
– MOD 11: HiLight E3+ TMR 110
List of abbreviations:
– TMR = Timer/Photocell option
– SKT = IN socket only
– 250 = 250W light output
– 110 = 110VAC power input