Reversing The Door - Brandt BFC38NW Guide D'installation Et D'utilisation

9. REVERSE THE DOOR
The side in which the door opens can be
changed from the right side (as supplied) to
the left side, if the installation site allows for
it. Tools you will need:
1. 8mm socket driver
2. Cross-shaped screwdriver
3. Putty knife or thin-blade screwdriver
1. Stand the refrigerator, open the upper
door and remove the door shelves
and close it(preventing the shelves are
damaged).
2. Use a putty knife or thin-blade screwdriver
to prize the screw hole cover which is at
the top left corner of the refrigerator, and
Unscrew the upper hinge cover which is
at the top right corner of the refrigerator.
screw hole cover
3. Unscrew the special flange self-tapping
screws which are used for fixing the right
upper hinge part by a 8mm socket driver
or a spanner (please support the upper
door with your hand when doing it).
right upper hinge
part
4. Remove the upper hinge axis, transfer it
to reversed side and tighten securely, then
put it in a safe place.
door shelves
5. Lift the upper door and set it on a non
scratching surface with the outside up,
then use a aluminate thing to prize the
handle covers and screw hole covers,
unscrew the special self-tapping screws
which are used for fixing the handle,
replace the handle to the right side, and
install it ,and replace the screw hole
covers to another side. Unscrew the self-
tapping screw which is used for fixing the
door stop and install the door stop on the
left side.
screw
upper hinge
cover (right)
pecial selftapping
screws
NOTE: When removing the door, watch for
washer(s) between the ceter hinge and the
bottom of the freezer door that may stick to
the door. Do not lose.
31
special flange
selftapping screws
handle covers
handle
screw hole covers
door stop
EN