Control Panel - Brandt BFC38NW Guide D'installation Et D'utilisation

EN

3. CONTROL PANEL

• Insert the plug of the connection lead
into the plug socket with protective
earth contact. When the refrigerator
compartment door is opened, the internal
lighting is switched on.
• After the fridge has been placed in
position,wait for 5 minutes before
electricity is supplied. Don't store anything
until the temperature inside the fridge
becomes low enough.
TEMPERATURE REGULATOR IN
REFRIGERATOR CHAMBER
• Insufficient refrigeration in chamber.
Set the temperature controller at
"COLDER" position.
• Using the refrigerator in normal condition.
Set the temperature controller at "MID"
position.
MID
COLD
Note:
Do not place the food on the air outlet,and
leave enough space for airflow.
Note:
When you turn the knob to lower which can
lead to the more energy efficiency.
Otherwise, it would result the energy-
consuming.
Important!
High ambient temperatures (e.g. on hot
summer days) and a cold setting on the
temperature regulator can cause the
compressor to run continuously or even
non-stop!
Reason: when the ambient temperature is
high, the compressor must run continuously
to maintain the low temperature in the
appliance.
BLOCK FOR WIND GATE IN
REFRIGERATOR CHAMBER
• In case of too much frozen food or
ice making in chamber. Please set the
temperature control knob at "COLDEST"
position.
• In case of using the refrigerator in usual
condition. Please set the temperature
regulator at the middle of " COLDEST"and
"COLD".
• In case of a little frozen food in chamber.
Please set the temperature controller at
"COLD" position.
Important!
Normally we advise you select setting at
the middle of "COLD" and "COLDEST",if
you want the temperature higher or
lower please turn the knob to "COLD" or
"COLDEST"setting accordingly.
COLDER
CHANGING THE LED LIGHT PART
Changing the light bulb carry out by
inexperienced persons may cause injury or
serious malfunctioning. it must be replaced
by a qualified persons in order to avoid a
hazard. Contact your local Service Force
Center for help.
• Before changing the LED light part, switch
off the appliance and unplug it, or pull the
fuse or the circuit breaker.
• LED light part date:220-240V~.
• Unplug the mains plug.
24
COLD
Warning! If the LED light bulb is
damaged, DO NOT CHANG IT BY THE
USER!
COLDEST