Brandt BFC38NW Guide D'installation Et D'utilisation page 32

EN 9. REVERSE THE DOOR
6. Unscrew the two special flange
selftapping screws which are used for
fixing the middle hinge part, then remove
the middle hinge part that hold the lower
door in place.
7. Lift the lower door and set it on a non
scratching surface with the outside up,
then operate the similar process of step 5.
handle covers
handle
special selftapping
screws
NOTE: When removing the door, watch for
washer(s) between the ceter hinge and the
bottom of the freezer door that may stick to
the door. Do not lose.
8. Remove the screw hole cover from the left
holes as illustrated and transfer them to
the uncover holes at the right side.
screw hole cover
screw hole cover
9. Lay the refrigerator on soft foam
packaging or similar material. Remove
both adjustable bottom feet parts, and
remove the front feet fixed board and
the lower hinge part by unscrewing the
special flange self-tapping screws.
front feet fixed board
special flange
selftapping screws
middle hinge
part
10. Unscrew the bottom hinge axis and
special flange
selftapping screws
11. Replace the lower hinge part to the left
screw hole covers
lower hinge part
12. Transfer the lower door to the property
screw hole cover
screw hole cover
32
ajustable bottom
feet part
remove it to the hole which is side-by-side
and screw it.
side and fixing it with the special flange
selftapping screws. Replace the front feet
fixed board to another side and fixing
it with the special flange self-tapping
screws. Install the ajustable bottom feet
parts,
position, adjust the lower hinge part,
make the hinge axis into the lower hole of
the lower door, then tight the bolts.
lower hinge part
ajustable bottom
feet part
special flange
selftapping screws
front feet fixed board