First Use And Installation - Brandt BFC38NW Guide D'installation Et D'utilisation

EN

4. FIRST USE AND INSTALLATION

CLEANING BEFORE USE
• Before using the appliance for the first
time, wash the interior and all internal
accessories with lukewarm water and
neutral soap in order to remove the typical
smell of a brand new product, then dry
thoroughly.
Important! Do not use detergents or
abrasive powders, as these will damage the
finish.
INSTALLATION POSITIONING
Warning! Before installing, read the
instructions carefully for your safety
and the correct operation of the
appliance.
• Position the appliance away from sources
of heat such as stoves, radiators, direct
sunlight, etc.
• Maximum performance and safety are
guaranteed by maintaining the correct
indoor temperature for the class of unit
concerned, as specified on the rating plate.
• This appliance performs well from N to ST.
The appliance may not work properly if it
is left for a longer period at a temperature
above or below the indicated range.
Important ! It is necessary to have good
ventilation around the refrigerator to allow for
the dissipation of heat, high efficiency, and
low power consumption. For this reason,
sufficiently cleared space should be available
around the refrigerator. It is advisable for
there to be 75 mm separating the back of
the refrigerator to the wall at least 100 mm of
space on its two sides, a height of over 100
mm from its top and a clear space in front to
allow the doors to open 160°.
100mm
100mm
• Appliances must not be exposed to rain.
Sufficient air must be allowed to circulate
in the lower rear section of the appliance,
as poor air circulation can affect
performance. Built-in appliances should
be positioned away from heat sources
such as heaters and direct sunlight.
Leveling
• The appliance should be level in order
to eliminate vibration. To make the
appliance level, it should be upright and
both adjusters should be in stable contact
with the floor. You can also adjust the
level by unscrewing the appropriate level
adjustment in the front (use your fingers or
a suitable spanner).
Electrical connection
Caution! Any electrical work required to install
this appliance should be carried out by a
qualified or authorized person.
Warning! This appliance must be grounded.
The manufacturer declines any liability should
these safety measures not be observed.
75mm
26
Climate class Ambient temperature
SN +10ºC to +32ºC
N +16ºC to +32ºC
ST +16ºC to +38ºC
T +16ºC to +43ºC