Troubleshooting - Brandt FP562BB Guide D'utilisation

99643801_A_ML.qxp 22/05/2007
EN

7 / TROUBLESHOOTING

If you have a doubt about the correct functioning of your oven, this does not neces-
sarily mean that there is a malfunction. In any event, check the following items:
YOU OBSERVE
THAT...
The oven is not heat-
ing.
The padlock is flash-
ing
The oven light is not
working.
The pyrolysis clean-
ing cycle does not
begin.
Your oven starts
beeping.
Warning
- Repairs to your appliance should only be performed by professionals. Non-standard re-
pairs may be a source of danger for the user.
Tip
In all circumstances, if your efforts are not sufficient, contact the After-Sales Service
Department without delay.
16:31 Page 70
POSSIBLE
CAUSES
- The oven is not connected
to the power supply.
- Your fuse is out of order.
- The selected temperature is
too low.
- Problem with the door's
locking mechanism.
- The light is out of order.
- The oven is not connected
or the fuse is not working.
- The door is not properly
closed.
- The locking system is defec-
tive.
- During cooking.
- At the end of a cooking cy-
cle.
70
WHAT SHOULD
YOU DO?
➡ Plug in your oven.
➡ Replace the fuse in your electrical
set-up and check its capacity (16A).
➡ Increase the selected temperature.
➡ Call the After-Sales Service Depart-
ment.
➡ Change the bulb.
➡ Plug in your oven or change the fu-
se.
➡ Verify that the door is locked.
➡ Call the After-Sales Service Depart-
ment.
➡ The recommended temperature of
your choice has been reached.
➡ Your programmed cooking cycle is
finished.