Table des Matières
Publicité
Control keys
^ Press once to activate the function, press again to
deactivate the function.
i
Manual operation
(Used by Miele Service Technicians)
See the Programming Manual.
FC
Functions
Press this key to temporarily select another language
and/or access the Supervisor level.
A
Back to the previous display
+ i
Block plus
The respective program block, e.g. prewash, will be
added to the program.
m
Starch Stop
Press this button to stop the program and allow
starch to be added to the laundry.
k
Spin Stop
Press this button if a final spin is not required after the
final rinse.
m
Delay start
Press this key to select a start time in the display.
K
Information
To show program information
f
Stop/Finish
Press to stop a selected program or to end an
already stopped program.
q
Drain
ü
Skip
Cycles of a program in progress can be skipped or
repeated.
e/-
Following or previous line
S
Save
See the Programming Manual.
$
Program locked
If a program is locked it cannot be stopped or ended
with the 0 "Off" button after 1 minute.
)
Program unlocked
ß
Dispensing
ä
Dispensing not available
\
Operating data
-> l <- Reset to 0 (zero)
To reset the load sensor to "00.0" when the drum is
empty and the display shows a load size.
Data transfer
D
Operator Card
No programs are saved on this card. To transfer the
data from the control to the card and vice versa see
the Programming Manual.
30 programs containing 6 blocks each can be saved
on the card.
The rear side of the card can be labeled.
Guide to the washer
9
Publicité
Chapitres
Table des Matières
