Table des Matières
Publicité
Frequently asked questions
Fault messages
,
Repairs to electrical or steam appliances
should only be carried out by a Miele authorized
technician in accordance with local and national
safety regulations. Unauthorized repairs could
cause injury or machine damage.
Faults that occur before or after the start of a program
flash in the display.
If the display remains off, the washer has no power.
^ Check the plug, main switch and fuses on-site.
Power failure
y
Program stop.
Press Start.
^ Press "START".
This fault message can also indicate that the overload
cut-out of the drive motors has over heated.
^ Allow the motor to cool.
Water intake fault
M
Contact Technical Service
if restart w/o success.
i
^ Check the water supply and press "START".
Door lock fault.
a
Contact Technical Service
if restart w/o success.
i
^ Press the door handle so that it closes with a click,
press "START".
26
Heating system fault
§
Program stop. Press Start.
Program runs with cold water..
i
^ Press "START" to continue the program without
heating.
If the program has a "Thermostop" the program will
time out.
^ Contact Miele Technical Service.
^ Some programs may be canceled if this messages
shows.
Contact Technical Service.
Drive motor fault
m
Program stop. Press Start.
Motor temperature too high.
i
^ Allow the motor to cool.
f
Imbalance fault
§
Contact Technical Service
if restart w/o success.
i
Large imbalance, the imbalance switch has
activated.
^ Turn the machine off and on again
f
^ Press "START".
Drain valve fault
q
Contact Technical Service
if restart w/o success.
i
f
^ Check and clean the drain system and press
"START".
A defective drain valve should only be replaced by
an authorized service technician.
f
f
A
f
Publicité
Chapitres
Table des Matières
