Filters; Changing The Motor Protection Filter - Rotel U6562CH Mode D'emploi

Filters

Your vacuum cleaner is equipped with the following filters:
o
Motor protection filter (Fig. 20/1) prevents larger particles from
damaging the motor in case the dust bag is defective.
o
Hygienic exhaust filter (HEPA) (Fig. 20/2) removes microscopic
particles from the exhaust air stream.
ATTENTION:
These filters are not washable. The exhaust filter is not reusable. Heavily soiled filters reduce
the performance of the vacuum cleaner. Therefore, it is important to adhere to the changing
intervals. Damaged filters must be removed immediately.

Changing the motor protection filter

o
Switch off the vacuum cleaner and remove the dust bag.
o
Remove the filter holder with motor protection filter (Fig. 22/1):
flip the filter holder forwards and then pull the filter up and out.
o
Remove the filter fleece (Fig. 23/1) from the filter holder (Fig.
23/2) over a waste bin.
o
Clean the filter holder.
o
If necessary, cut the new motor protection filter to size it to the
holder.
o
Replace the filter holder and push it down until it audibly locks
into place.
o
Replace the dust bag and properly close the dust compartment
cover.
NOTE:
lf the motor protection filter is only slightly dirty, shake or beat out the dust over a waste bin.
Replace every time you open a new box of dust bags, as it always contains a new motor pro-
tection filter, or at least every six months.
Gebrauchsanweisung ○ Mode d'emploi ○ Istruzioni per l'uso ○ Instructions for use
49