Replacing Or Cleaning The Filters - Rotel MICROCYCLONE6744CH Mode D'emploi

• REPLACING OR CLEANING THE FILTERS

Clean the dust compartment filter at least twice a year or when it becomes visibly dirty. Always
operate the vacuum cleaner with its filters installed. Reduced suction power or motor damage
may occur if the filters are not replaced or cleaned in good time. Disconnect from power
source before cleaning filters. Do not use a washing machine to clean the dust compartment
filter and allow to air-dry thoroughly before placing it back in the device.
o Motor filter (motor protection)
Remove the bin out of the vacuum cleaner.

Pull the fine dust filter out and remove the foam pad (fine dust filter).

The fine dust filter (foam pad) can be cleaned under running water. Make sure the filter

dries thoroughly before putting it back in.
o HEPA filter
highly effective HEPA filter fulfils the stringent requirements of the protection
The

class for suspended particles and is therefore particularly suitable for people who
suffer from allergies and respiratory problems. For best results, the filter should be
replaced every two years.
 To replace the filter, open the lid and take out the HEPA filter, check it and if neces-
sary, replace it with a new one. Then insert the cover back into the housing and press
gently until you hear it click into place.
Gebrauchsanweisung ○ Mode d'emploi ○ Istruzioni per l'uso ○ Instructions for use
28