Maintenance; Regular; Checking.wear.on.brake.pads - Magura MT7 Mode D'emploi

r
egular
How frequently you need to maintain your MAGURA product
L
depends on how often you use it, but also on weather conditions.
Perform the following maintenance steps more frequently if you
use your bicycle in extreme conditions (rain, dirt, high mileage,
etc.).
If you are a frequent user, also consider the fact that this exposes
your MAGURA product to more wear and thus requires more
frequent maintenance intervals and checks.
Corrosion and material damage due to water penetration.
Never use a pressure or steam cleaner to clean your bicycle –

the seals on your bicycle components are not built to withstand
this pressure.
You should even exercise care if you use a water hose. Never

point the water jet directly at seal areas
Clean the brake and disc brake rotors with water, detergent and
)
a brush.
Thoroughly degrease the disc brake rotor using brake cleaner or
)
spirits.
Inspect brake pads and disc brake rotors for wear and damage
)
(cracks, deformation, etc.) at regular intervals.
– see
c
hecking wear on Brake paDs anD Disc Brake rotors
– see , page 32,
c
hanging Brake paDs
– see , page 25.
installing disc brake rotor
Pull and hold the brake lever blade several times and check:
)
No oil is leaking from any part of the brake system.
Pressure point is clearly noticeable and does not change.
Bleed brake if necessary – see
Check and if necessary tighten screws on brake lever
)
mounting base ], brake calliper
[ a1
and hose connection (RHR) [
a8
[ ].
e1
, page 31,
, page 33.
B
leeDing anD filling Brake
[ ],
a3
], disc brake rotor
[ a2 ] [ a6 [ a5
] at regular intervals.

MaIntenanCe

c
hecking wear on Brake paDs anD Disc Brake rotors
The MAGURA brake pad is considered worn if the thickness t
L
(pad + pad carrier plate) is less than 2.5 mm at any point.
The MAGURA disc brake rotor is considered worn if the thickness
t is less than 1.8 mm at any point.
... with wheel installed and brake pads mounted:
Danger of injury on sharp or hot disc brake rotor
Always keep away from rotating disc brake rotor.

Always keep away from hot disc brake rotor after braking.

Make sure that the thickness t of the disc brake rotor is not less
)
than 1.8 mm at any point.
Pull and hold brake lever blade.
)
Make sure that the wear gauge
)
between the pad carrier plates of the brake pads
Brake pads have not reached the wear limit.
Ö
... with brake pads removed:
Check brake pads for damage (cracks, etc.).
)
Make sure that the brake pads do not fit into the wear gauge
)
the transport device at any position
Brake pads have not reached the wear limit.
Ö
Replace damaged or worn brake pads or disc brake rotors with
)
new parts.
– see , page 32,
c
hanging Brake paDs
– see
installing disc brake rotor
]
of the transport device fits
1
( )
[ ].
F1
[ ].
F1
, page 25.
of
2
( )
31