Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
If it is necessary to route the brake hose of your rear-wheel brake
L
inside the bike frame, you must open the brake system at the
brake lever – see
shortening brake hose
If necessary, shorten the brake hose for this.
A thin wire may be helpful for inserting through the bike frame.
L
Thread it through the openings of the frame in the opposite direc-
tion and attach it to the end of the brake hose with adhesive tape.
However, do not insert the wire into the brake hose – oil loss!
Use the MAGURA hose plug.
Carefully pulling with the wire and pushing the brake hose at the
same time will make it easier to find the outlet.
, page 27.
[
]
B3
InstallatIon
Shortening brake hose
The brake hose may have to be disconnected from the brake lever for
the following steps.
Loss of oil when the brake hose is removed/disconnected.
Do not actuate the brake lever blade if the brake hose is dis-
connected.
Handle the open brake hose carefully – do not shake it, knock it
or hit it.
Have clean, absorbent and lint-free cloths ready – wipe any
leaking oil away immediately.
Unusable brake hose – because it is too short.
Before shortening the brake hose make sure that the handlebar
and stem are in their final position and do not need to be raised,
extended or adjusted in any way.
Make sure that there is full steering movement in both directions.
Make sure that all suspension can function freely.
If required, allow a little longer at first – you can always shorten
it a bit more but you can't extend it!
Do not cut the brake hose with side cutters or a saw.
Cut the brake hose with a suitable wire cutter (e. g. MAGURA wire
cutter) or a sharp knife only.
Remove the wheel.
)
Carefully press brake pads apart to the stop with transport
)
device or a wide screwdriver.
Loosen the lower clamping screw
)
Turn the brake lever so it is pointing vertically upwards
)
Tighten the bottom clamping screw
)
4 N·m (35 lbf·in).
Push the hose cover
upwards
1
(
)
)
[
].
a3
3
(
)
[
].
B1
with tightening torque of
[
].
B1
27
Publicité
Table des Matières
