Calling And Exiting The User Menu; Performing Settings In The User Menu - Blaupunkt San Francisco 300 Mode D'emploi Et De Montage

FADER
Front/rear volume distribution. Settings: R9
(rear) to F9 (front).
button > to open the sub-
Press the
u
menu.
Press the button
u
the setting.
X-BASS
Increase of bass at low volume. Settings: 0 (off) to
3 (highest increase).
button > to open the sub-
Press the
u
menu.
Press the button
u
the setting.
Calling and exiting the enhanced
audio menu
In the audio menu, select the "ENHANCED"
u
menu item.
button > to open the EN-
Press the
u
HANCED menu.
Press the button
u
until the desired menu item is selected.
Perform the setting (see the next section).
u
Briefl y press the MENU•OK button ? to
u
select a different menu item.
- or -
Briefl y press the DIS/ESC button = to exit
u
the menu.
Performing settings in the enhanced
audio menu
E-BASS
Adjusting bass frequency and quality factor. Set-
tings:
• Bass frequency: 60/80/100/200 Hz
• Quality factor: 1.0/1.25/1.5/2.0
button > to open the E-BASS
Press the
u
submenu.
02_SanFrancisco300_gb_0309.indd 37
@ / 2 to perform
@/ 2 to perform
@/ 2 repeatedly
@ /
Press the button
u
tween the submenus "FREQ" (frequency) and
"QFAC" (quality factor).
5 /
Press the button
u
tween the available settings of the submenu.
E-TREBLE
Setting the treble frequency.
10/12.5/15/17.5 kHz.
button > to open the E-TREBLE
Press the
u
submenu.
5 /
Press the button
u
tween the available settings of the submenu.
E-MIDDLE
Setting the middle level and frequency as well
as quality factor. Settings:
• Middle level: -7 to +7
• Centre frequency: 0.5/1.0/1.5/2.5 kHz
• Quality factor: 0.5/0.75/1.0/1.25
button > to open the E-MIDDLE
Press the
u
submenu.
@ /
Press the button
u
tween the submenus "GAIN" (level), "FREQ"
(frequency) and QFAC (quality factor).
5 /
Press the button
u
tween the available settings of the submenu.
E-XBASS
Setting the X-bass level and frequency. Settings:
• X-bass level: 0 (off) to 3
• X-bass frequency: 30/60/100 Hz
button > to open the E-XBASS
Press the
u
submenu.
@ /
Press the button
u
between the submenus "GAIN" (level) and
"FREQ" (frequency).
5 /
Press the button
u
tween the available settings of the submenu.
Sound settings
2 to change be-
> to change be-
Settings:
> to change be-
2 to change be-
> to change be-
2 to change
> to change be-
37
26.03.2009 13:20:30 Uhr