Abus RM40Li Manuel Utilisateur page 32

Putting into operation
 3UHVV WKH WHVW EXWWRQ RQ WKH VHFRQG GHWHFWRU IRU DSSUR[ VHFRQGV WR VHW WKLV
detector in addressing mode too.
 7KH GHWHFWRUV H[LW DGGUHVVLQJ PRGH DXWRPDWLFDOO\ D HU
4. The addressing process can take up to 60 seconds. When the detectors have been
successfully trained, the LED on both detectors lights up for around 5 seconds,
D HU ZKLFK WKH GHWHFWRUV H[LW DGGUHVVLQJ PRGH ,I WKLV ZDV QRW VXFFHVVIXO WKH
GHWHFWRU ZLOO UHWXUQ WR VWDQGDUG PRGH DXWRPDWLFDOO\ D HU
5. If you wish to connect several detectors together,
\RX ZLOO QHHG WR GH QH D FHQWUDO GHWHFWRU
with which you can connect the other detectors.
Proceed with points 1 to 4 as described to connect
the detectors in a network.
 7KH GHWHFWRUV ZLOO H[FKDQJH WKHLU DGGUHVVLQJ GDWD
with another.
Reset default factory settings/separate network connections
In order to reset the smoke detectors to the default factory settings
• Press the test button and hold it down.
$ HU DSSUR[ VHFRQGV WKH /(' ZLOO DVK RQFH D VHFRQG $ HU DQRWKHU
WKH /(' ZLOO DVK PRUH IUHTXHQWO\ DSSUR[ WZLFH D VHFRQG 
• Now let go of the button. If a short beep is heard, the procedure was successful.
All network connections between the detectors have then been separated.
Muting the detector
If an alarm has been triggered, the wireless smoke detector can be muted by
pressing the test button. In the case of networked detectors, the mute button on
the activated detector can also silence the alarm of the other networked detectors.
VHFRQGV
– 32 –
VHFRQGV
VHFRQGV