Publicité
Les langues disponibles
Les langues disponibles
Before putting into operation
The accumulator is supplied partially charged. It must be
charged to full extent before it is put into operation for the
first time.
CAUTION:
Charge the accumulator only using a charged
•
included in the supply.
Use only sharp drills and screw bits that are in a
•
perfect and appropriate condition.
When drilling and screwing to walls, check
•
whether there are no electric lines or water piping or
gas lines in the wall.
Operation
Battery charging:
1.
The battery will be released from the appliance by
pressing the lock-in buttons (pic. G/12) and putting it
out.
2.
Now check if the system voltage details given on the
charger type label match the existing system voltage.
3.
Plug the charger and connect the charging cable to
the charging connection.
4.
"Red" LED is on when the battery is being charged
(pic. H/13).
5.
"Green" LED is on when charging is completed (pic.
H/13).
To ensure long service life of the accumulator, timely
charging should be provided at all times.
If the accumulator is shortly before being discharged, it
switches off. In any case, do not use the cordless
screwdriver any more. Doing so could dramatically reduce
the service life of the accumulator.
Torque adjustment:
Torque can be adjusted depending on the size of screws
on the torque adjustment device (pic. D/9).
Torques depends on a number of factors:
Type and hardness of material you are working
•
with.
Type and length of the screws that are used.
•
Requirements imposed on the screwed joints.
•
Adjust the torque only when the cordless
screwdriver is idle.
Drilling:
To drill, adjust the torque (pic. D) to the final "drilling" level.
Mode selector:
Selector to be controlled only when the cordless
screwdriver is idle.
Screwing mode
•
Lower speed, higher torque.
Drilling mode
•
Higher speed, lower torque.
Rotation direction switching:
The rotation direction may be adjusted by the shift switch
(pic. C/8). You can choose between the right and left
rotation. To prevent damage of the gearing, the rotation
direction may only be changed when the appliance is idle.
If the switch is in the central position, On/Off is blocked.
On/Off:
The more this switch (pic. C/7) is pressed, the higher the
cordless screwdriver speed.
Tool clamping/change:
When working on the cordless screwdriver,
adjust the rotation direction switch (pic. B/7) to the
central position.
1.
Screw the chuck (pic. B/10) out to remove the tool.
2.
Now choose the appropriate tool and insert it as deep
in the hole as possible.
3.
Screw the chuck tightly again and check whether the
tool is fitted tightly.
LED light:
LED light (pic. B/11) enables additional lighting of the
screwing or drilling space. LED light is immediately
switched on after pressing On/Off
Marking
Product safety:
Product corresponds to
applicable EU standards
Commands:
Please read the Operating
Instructions before using the
appliance
Environment protection:
Any defective and/or disposed
electric or electronic devices
must be delivered to respective
collection centres.
Package:
Protect against moisture
Technical specifications:
Chuck clamping range
Weight
Battery voltage/capacity
Torque levels
8
This side up
Revolutions
Right/left running
Nm = max. torque
Battery charging time
Publicité
